IBV/600 M1-P

This machine enables to square the first and final parts of big thickness strips of Marble and Granite, and also the cut at programmable measure, and the possibility to step-cut (suggested for hard materials). The grinded table with belt is fixed on the structure made of electro-welded steel. The table carries a special rubber belt and it is resistant to wear. A special anticorrosive treatment is effected. The switch board is made of sheet steel, thickness 15/10 mm, painted with RAL 7032 paint, IP 55 protection level. The supplying unit is composed by a magnetothermic switch with shutter locking to avoid the opening of the switch board with tension. It can be restored after opening the shutter, in case of maintenance.

- length of table with motorized belt mm 4000

- disc diameter max mm 750

- shaft diameter for disc fixing mm 50

- cutting unit motor power kW 15

- cutting unit forwarding motor power kW 0,55

- cutting speed electronic adjustment by inverter

- belt forwarding motor power kW 1,5

- electronic adjustment of belt speed

- useful cutting width mm 600 (mm 800 on request)

- useful thickness of working marble mm 250 (for both marble and Granite)

- disc motor number of revolutions marble-granite rpm 1450

- water consumption l/min 30

- total installed power kW 17

- unit of cut predisposed for multiple passings

programmable on touch screen, with the possibility

to set n. 9 measures repeatable individually

Optional:

- motorized belt L=4000 with laser pointer. It slides on linear guide to set cuts and perform them on strips to be positioned at the entry side of heading machine. The cut automatic cycle of the machine starts after ending the selection of the cuts to perform (max 10 positions) and simply pressing a push-button positioned on the sliding control panel